Multi-information display indications
Monochrome display
- LDA indicator
The color in which the indicator lights up informs the driver of the operating state of the system.Lights white: The LDA system is operating.
Lights green: The steering assist of the active steering assist function is operating.
Flashes orange: The lane departure alert function is operating.
- Steering assist operation display
Indicates that the steering assist of the active steering assist function is operating. - Lane departure alert function display
Displayed when you switch from the multi-information display to the driving support system information screen.
Inside of white lines displayed in white:

Indicates that the white (yellow) lines are recognized by the system. When the vehicle drifts out of its lane, the displayed white line on the side toward which the vehicle is drifting flashes orange.
Inside of white lines displayed in black:

Indicates that the white (yellow) lines are not recognized by the system, or that the system is temporarily deactivated.
Color display
- LDA indicator
The color in which the indicator lights up informs the driver of the operating state of the system.Lights white: The LDA system is operating.
Lights green: The steering assist of the active steering assist function is operating.
Flashes orange: The lane departure alert function is operating.
- Steering assist operation display
Indicates that the steering assist of the active steering assist function is operating. - Lane departure alert function display
Displayed when you switch from the multi-information display to the driving support system information screen.
Inside of white lines displayed in white:

Indicates that the white (yellow) lines are recognized by the system. When the vehicle drifts out of its lane, the displayed white line on the side toward which the vehicle is drifting flashes orange.
Inside of white lines displayed in black:

Indicates that the white (yellow) lines are not recognized by the system, or that the system is temporarily deactivated.
■ Operating conditions of each function
- Lane departure alert function
The function operates when all of the following conditions are met.- LDA is on.
- The vehicle is traveling at more than approximately 50 km/h.
- The white (yellow) lines are recognized by the system.
- The driving lane is wider than approximately 3 m (9.8 ft.).
- You are not operating the turn signal lever.
- The vehicle is traveling in a straight line or on a long curve with a turning radius greater than approximately 150 m (492 ft.).
- No system malfunction is detected.
- Active steering assist function
This function operates when all of the following conditions are met, in addition to the operating conditions of the lane departure alert function.- Monochrome display: The active steering assist on/off mode is set to on
(on) on the screen
. - Color display: The "
Steering assist" option is set to on on the screen
. - You do not accelerate or decelerate the vehicle beyond a set speed difference.
- You do not turn the steering wheel with enough force to change lanes.
- The ABS, VSC, TRC and PCS systems are not operating.
- The TRC or VSC system is not turned off.
- The hands-off steering wheel alert is not displayed.
- Monochrome display: The active steering assist on/off mode is set to on
- Vehicle sway warning
The function operates when all of the following conditions are met.- Monochrome display: The sway warning on/off mode is set to on
. - Color display: The "
Warning" option is set to on on the screen
. - The vehicle is traveling at more than approximately 50 km/h.
- The driving lane is wider than approximately 3 m (9.8 ft.).
- No system malfunction is detected.
- Monochrome display: The sway warning on/off mode is set to on
■ Temporary deactivation of functions When the operating conditions are no longer met, a function may be temporarily deactivated. However, when the operating conditions are met again, the function is automatically reactivated.
■ Active steering assist function Depending on vehicle speed, lane departure situation, road conditions, etc., the operation of the functions may not be noticeable, or the function may not operate at all.
■ Lane departure alert function The audible alert may be difficult to hear due to outside noise, audio playback, etc.
■ Hands-off steering wheel alert When the system determines that the driver has removed their hands from the steering wheel while the active steering assist function is operating, an alert message is displayed on the multi-information display.
If the driver continues not to return their hands to the steering wheel, a buzzer sounds, an alert message is displayed and the function is temporarily deactivated. This alert also occurs in the same way when you drive the vehicle without holding the steering wheel firmly enough. However, depending on road conditions, etc., the function may not be deactivated.
■ White (yellow) lines on only one side of the road The lane departure alert system does not operate on the side where the white (yellow) lines could not be recognized.
■ Conditions in which the functions may not operate correctly In the following situations, the camera sensor may fail to detect the white (yellow) lines and the various functions may not operate normally.
- Shadows run across the road parallel to the white (yellow) lines, or obscure them.
- The vehicle is traveling in an area without white (yellow) lines, such as before a toll gate or checkpoint, or at an intersection, etc.
- The white (yellow) lines are cracked, or there are road studs or paving blocks.
- The white (yellow) lines are invisible or difficult to distinguish due to sand, etc.
- The vehicle is traveling on a road surface wet from rain, puddles, etc.
- The road markings are yellow (which may be more difficult to recognize than white lines).
- The white (yellow) lines cross a curb, etc.
- The vehicle is traveling on a glossy road surface, such as concrete.
- The vehicle is traveling on a road surface made glossy by light reflections, etc.
- The vehicle is traveling in an area where the ambient brightness changes suddenly, such as when entering or exiting a tunnel, etc.
- The camera is directly exposed to light from the headlights of an oncoming vehicle, the sun, etc.
- The vehicle is driving at a fork or junction, etc.
- The vehicle is driving on a slope.
- The vehicle is driving on a road that turns left or right, or on a winding road.
- The vehicle is driving on an unpaved road or a road in poor condition.
- The vehicle is taking a sharp turn.
- The driving lane is excessively wide or narrow.
- The vehicle is tilted significantly because it is carrying heavy luggage or its tires are underinflated.
- The distance to the vehicle ahead is extremely short.
- The vehicle moves up and down significantly while driving due to road conditions (poor road surface, cracks in the road).
- The headlight lenses are dirty and their light output is weak at night, or their beam is misaligned.
- The vehicle is hit by a crosswind.
- The vehicle has just changed lanes or crossed an intersection.
- The vehicle is fitted with snow tires, etc.
■ Warning message If the following warning message is displayed on the multi-information display, perform the indicated troubleshooting procedure.
| Warning message | Explanation/Action |
| "LDA malfunction. Visit your dealer." | The system may not operate normally. → Have the vehicle inspected by a Toyota dealer, a Toyota authorized repairer, or any reliable repairer. |
| "Front camera view obstructed. Clean and defog the windshield." | Dirt, rain, condensation, frost, snow, etc., on the part of the windshield in front of the camera sensor. → Turn off the LDA system, clean the windshield or remove water, condensation, frost, snow, etc., then turn the LDA system back on. |
| "Front camera unavailable" | The camera sensor operating conditions (temperature, etc.) are not met. → When the camera sensor operating conditions (temperature, etc.) are met, the LDA system becomes available again. Turn off the LDA system, wait a few minutes, then turn it back on. |
| "LDA unavailable" | The LDA system is temporarily deactivated because a sensor other than the camera is malfunctioning. → Turn off the LDA system and perform the troubleshooting procedure for the corresponding warning message. Then, drive the vehicle for a few kilometers, then turn the LDA system back on. |
| "LDA unavailable below approximately 50 km/h" | The system cannot be used because the vehicle is traveling below approximately 50 km/h. → Drive the vehicle above approximately 50 km/h. |
If a different warning message is displayed, follow the instructions on the screen.
■ Customization The following functions can be customized.
| Function | Customizable setting |
| Lane departure alert function | Alert sensitivity adjustment |
| Active correction function | Steering assist on/off |
| Vehicle weaving alert | Function on/off |
| Alert sensitivity adjustment |