Toyota Sienna Quiz
Navigation

Camera Picture Error

In this manual: Navigation
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
8steps
~48min
2/5difficulty
Done 0 of 8

DTC 5C-40 Camera Picture Error

DESCRIPTION

DTC No.

DTC Detection Condition

Trouble Area

5C-40

 Synchronous signal from the camera cannot be transmitted.
  • Wire harness
  • Television camera assembly
  • Radio and navigation assembly

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION CAMERA ASSEMBLY)

  1. Disconnect the R10 connector from the radio and navigation assembly.
  2. Disconnect the T10 connector from the television camera assembly.
    CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION
  3. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

2 INSPECT RADIO AND NAVIGATION ASSEMB

  1. Reconnect the radio and navigation assembly connector.
    INSPECT RADIO AND NAVIGATION ASSEMB
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

3 INSPECT TELEVISION CAMERA ASSEMBLY

  1. Reconnect the radio and navigation assembly R10 connector and the television camera assembly T10 connector
    INSPECT TELEVISION CAMERA ASSEMBLY
    INSPECT TELEVISION CAMERA ASSEMBLY
  2. Check the waveform of the television camera assembly using an oscilloscope.
  3. Measurement terminal: CV+ - CVMeasurement setting: 0.2 V/DIV, 0.2 μs/DIV Condition: Ignition switch ON, Shift lever in R range

OK: Pulses as shown in the illustration.

REPLACE RADIO AND NAVIGATION ASSEMBLY

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.