Toyota Sienna Quiz
Navigation

SPD Signal Error

In this manual: Navigation
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

DTC 58-43 SPD Signal Error

DTC 80-43 SPD Signal Error

DESCRIPTION

DTC No.

DTC Detection Condition

Trouble Area
58-43 A difference between the GPS speed and SPD pulse is detected.
  • Speed signal circuit
  • Radio and navigation assembly
80-43 A difference between the GPS speed and SPD pulse is detected

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
  1. Enter the "Navigation Check" mode (Vehicle Sensors).
  2. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

OK: The readings are almost equal.

2 PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Refer to "Speed signal does not change in the navigation check mode" in the problem symptoms table.

END

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.