Sound Signal Circuit between Radio and Navigation Assembly and Television Display Assembly

DESCRIPTION

The television display assembly sends an RSE sound signal to the radio and navigation assembly through this circuit. The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio and navigation assembly or speakers.

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)

1. 1
   Disconnect the connectors from the television display assembly and radio and navigation assembly.
2. 2
   Measure the resistance according to the value(s) in the table below.

Standard resistance

2 INSPECT TELEVISION DISPLAY ASSEMBLY

1. 1
   Reconnect the television display assembly connector and radio and navigation assembly connectors.
2. 2
   Check the waveform according to the conditions in the table below

Standard resistance

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE