Toyota Sienna Quiz
Navigation

Transmission Error

In this manual: Navigation
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
6steps
~36min
2/5difficulty
Done 0 of 6

DTC 01-DC Transmission Error

DESCRIPTION

DTC No.

DTC Detection Condition

Trouble Area
01-DC *1 Transmission to component shown by sub-code failed.
(Detecting this DTC does not always mean actual failure.) If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code

HINT: *1: This code may be stored if the engine is started, idled for 60 seconds and then the ignition switch is turned to the START position again.

NOTICE:

  • Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  • The radio and navigation assembly is the master unit.
  • Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE

NOTICE: Be sure to read DESCRIPTION before performing the following procedures

1 CHECK FOR DTC OF OTHER COMPONENTS

  1. Check if the component shown by the sub-code is displayed in the check result of the other components.
  2. Check if "01-DC" is output for the other components.
  3. If "01-DC" is output for any other components, check if the same physical address is displayed.

HINT: For the list of the components shown by sub-codes, refer to the table in step 2.

Result

Result

2 IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE

IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE
  1. Enter the diagnostic mode.
  2. Press the "LAN Mon" switch to change to "LAN Monitor" mode.
  3. Identify the component which has stored this code.

Component Table:

Component Table

HINT: "NAVI" is the component which has stored this code in the example shown in the illustration.

3 CHECK COMPONENT WHICH HAS STORED THIS CODE

  1. Select the component which has stored this code.

Component Table:

Component Table

END

4 CLEAR DTC

  1. Clear the DTCs.

HINT: If "01-DC" is output for only one component, this may not indicate a malfunction.

5 RECHECK DTC

  1. Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears

END

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.