Power steering fluid - Fluid level. Air conditioning - Troubleshooting and repair. Bulb replacement - General

Checking the power steering fluid on the Volvo S80 (2nd generation, 2013–2016) is an important part of maintenance. This section explains how to check the level without opening the cap and stresses the importance of a clean work area. Additionally, the basics of air conditioning troubleshooting and notes on safe bulb replacement are provided. Tips on choosing a workshop and precautions for xenon bulbs complete the information.

Power steering fluid - Fluid level

The power steering fluid level must be between the MIN and MAX marks on the reservoir. The fluid does not need to be replaced.

Check the fluid level at every service.

The fluid does not need to be replaced. The fluid level must be between the MIN and MAX marks.

For the recommended fluid quality, see Power Steering Fluid - Quality.

If there is a fault in the power steering system, or if the engine is switched off and the vehicle must be towed, the vehicle can still be steered.

Air Conditioning - Troubleshooting and Repair

Maintenance and repairs on the air conditioning system may only be performed by an authorized workshop.

Troubleshooting and Repair

The air conditioning system contains a fluorescent leak detection additive. Use UV light when searching for leaks.

Volvo recommends that you contact a Volvo workshop.

The air conditioning system contains pressurized R134a refrigerant. Maintenance and repairs on the system may only be performed by an authorized workshop.

Related information

- Volvo Service Program

Bulb Replacement - General

Bulb replacement can be performed for incandescent bulbs. For replacement of LED and xenon lights, please contact a workshop.

The incandescent bulbs are specified. Incandescent bulbs and other special light sources, such as LED8 lamps or lamps that must be replaced in a workshop9 for other reasons, include those listed in:

• Active Xenon Headlamps - ABL (Xenon Bulbs)
• Front position lights/parking lights
• Daytime running lights
• Side turn signal, exterior mirror
• Automatic lighting, exterior mirror
• Interior lighting
• Rear position lights/parking lights
• Rear side marker lights
• Brake lights.

8 Light Emitting Diode

9 A Volvo authorized workshop is recommended.

If the vehicle is equipped with xenon headlamps, the xenon bulbs must be replaced in a workshop. A Volvo authorized workshop is recommended. Working on xenon bulbs requires special care due to the high voltage of the headlamp.

The vehicle's electrical system must be in key position 0 when replacing a bulb, see Key Positions - Functions in Different Positions.

Never touch the glass of the bulbs directly with your fingers. Grease from your fingers will be vaporized by the heat and form a deposit on the reflector, which can be damaged as a result.

If a fault message continues to be displayed after replacing a defective bulb, it is recommended that you visit a Volvo authorized workshop.

Condensation may temporarily form on the inside of exterior lighting, e.g. headlamps, fog lamps and tail lights. This is a natural phenomenon for which the exterior lighting is designed. Condensation normally escapes from the lamp after it has been switched on for a while.

Related information

- Bulb Replacement - Headlamp

- Bulb Replacement - Rear Lamp Locations

- Replacing bulbs - vanity mirror lighting

- Bulb Replacement - Luggage Compartment Light

- Bulb Replacement - License Plate Light

The power steering fluid level in the Volvo S80 (2nd gen) must be between the MIN and MAX marks. Replacing the fluid is not required. Check it as part of regular maintenance; do not open the cap.

Repairs on the air conditioning system may only be performed at a specialist workshop. The same applies to replacing LED or xenon lights due to the high voltage. This ensures safety.

Volvo sets clear guidelines to avoid damage to the vehicle and injuries.