Wiper Blades

Replacing the wiper blades on the Volvo S80 (2nd gen, 2013–2016) requires using the service position. This section describes the steps to activate this position and how to replace the wiper blades safely. Cleaning and inspection of the blades are also covered to extend their service life. Tips for avoiding paint damage and for correct use of the jack increase safety during maintenance work.

The windshield wiper blade must be in the service position so that it can be replaced.

Service position

Wiper blades in service position.

To replace, clean, or lift the wiper blades (for example, to remove ice from the windshield), the wiper blades must be in the service position.

Before moving the wiper blades to the service position, make sure they are not frozen to the windshield.

1. 1
   Insert the transponder key into the ignition lock10 and briefly press the START/STOP ENGINE button to switch the vehicle's electrical system to key position I. For more detailed information about key positions, see Key positions - Functions at various levels.
2. 2
   Briefly press the START/STOP ENGINE button again to switch the vehicle's electrical system to key position 0.
3. 3
   Within 3 seconds, move the right steering column lever up and hold it for approx. 1 second.

   > The wipers move to the upright position.

The wiper blades return to their starting position by briefly pressing the START/STOP ENGINE button to switch the vehicle's electrical system to key position I (or when starting the vehicle).

10 Not required on vehicles with keyless function.

If the wiper arms have been raised away from the windshield in the service position, they must be folded back down to the windshield before returning to the starting position. This prevents scratching the paint on the hood.

Replacing the wiper blades

1. 1
   Raise the wiper arm when it is in the service position. Press the release button on the wiper blade attachment and pull the wiper blade straight out, parallel to the wiper arm.
2. 2
   Slide the new wiper blade on until it clicks into place.
3. 3
   Make sure the blade is securely attached.
4. 4
   Fold the wiper arm back down onto the windshield.

The wiper blades return from the service position to their starting position by briefly pressing the START/STOP ENGINE button to switch the vehicle's electrical system to key position I (or when starting the vehicle).

The wiper blades are different lengths. The driver-side blade is longer than the passenger-side blade.

Cleaning

For cleaning the wiper blades and windshield, see Car wash

Check the wiper blades regularly.

Neglected maintenance shortens the service life of the wiper blades.

Related information

- Washer fluid - Filling

The wiper blades on the Volvo S80 (2nd generation) must be moved into service position before they are replaced. This is done using the right-hand steering column lever. To replace a blade, release the locking tab and pull the blade off.

The blades are different lengths. The driver's side blade is longer. Checking and cleaning the blades regularly helps maintain good visibility and extends their service life. Volvo recommends using only genuine Volvo parts.

The service position also makes it easier to de-ice and clean the windscreen in winter.