Anti-lock Brake System (ABS)

WARNING An Anti-lock Brake System (ABS) or Electronic Stability Control (ESC) does not prevent accidents caused by improper or dangerous maneuvers. Even though vehicle control improves during emergency braking, always keep a safe distance between your vehicle and objects in front of you. Always reduce speed under extreme road conditions. Braking distance on vehicles equipped with ABS or ESC may be longer than on vehicles without them under the following road conditions. - Under these conditions, drive at reduced speed: - Rough roads, roads covered with snow, or gravel roads. - Roads with uneven surfaces or differing heights. - Snow chains are installed on the vehicle. Do not test the safety functions of a vehicle equipped with ABS or ESC by driving or cornering at high speed. This endangers your own safety and that of others.

ABS is an electronic braking system that helps prevent wheel slip. ABS allows the driver to steer and brake at the same time.

Using ABS

To get the maximum benefit from ABS in an emergency, do not attempt to modulate brake pressure and do not pump the brake pedal.

Have the tire repaired as soon as possible.

When braking in conditions that may lock the wheels, you may hear a ticking noise from the brakes, or feel a corresponding sensation through the brake pedal. This is normal and indicates that ABS is active.

ABS does not reduce the time or distance needed to stop the vehicle.

Always maintain a safe distance from the vehicle ahead.

ABS does not prevent skidding caused by sudden changes of direction, such as attempting to take a corner too fast or making a sudden lane change. Always drive at a speed that is safe for road and weather conditions.

ABS cannot prevent loss of stability.

Always steer moderately during hard braking. A sudden steering movement may cause the vehicle to leave its lane or run off the road.

On uneven surfaces, using ABS may result in a longer stopping distance than vehicles with a conventional braking system.

The ABS warning light () stays on for several seconds after the ignition switch is turned to ON. During this time, ABS performs a self-check, and the light goes off if everything is working normally. If the light stays on, there may be a problem with ABS. It is recommended that you contact an authorized HYUNDAI dealer as soon as possible.

WARNING If the ABS warning light () is on and stays on, there may be a problem with the system. Conventional (power-assisted) brakes still work normally. To reduce the risk of serious injury or death, it is recommended that you contact an authorized HYUNDAI dealer as soon as possible. NOTICE When driving on a road with poor traction, such as an icy road, and the brakes must be applied continuously, the ABS also operates continuously and the warning light () may come on. Bring the vehicle to a safe place and turn off the engine. Restart the engine. If the ABS warning light is off, the system is operating normally. Otherwise, there may be a problem with the ABS. It is recommended that you contact an authorized HYUNDAI dealer as soon as possible.

NOTE

When starting the vehicle from another battery due to a discharged battery, the engine may not run normally and the ABS warning light () may come on.

This is due to low battery voltage. It does not mean that ABS is not working properly. Recharge the battery before driving the vehicle.