Hyundai Kona Quiz
Engine Control System/Fuel System

Camshaft Position Sensor (CMPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
7steps
~42min
4/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Check the CMPS and CKPS signal waveforms using the GDS.

    Specification: Refer to "Waveform"

Removal

[Bank 1 / Intake]
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the sensor by loosening the mounting bolt (B).
  4. Turn the ignition OFF and disconnect the negative (-) battery cable.
  5. Remove the air cleaner. (Refer to Engine Mechanical System - "Air Cleaner")
  6. Disconnect the camshaft position sensor connector (A).
  7. Remove the camshaft position sensor (B) after loosening the mounting bolt.
[Bank 1/Exhaust]

Installation

  1. Install in the reverse order of removal. Camshaft position sensor mounting bolt: 7.8–11.8 N·m

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.