Hyundai Kona Quiz
Engine Control System/Fuel System

Exhaust Gas Temperature Sensor (EGTS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
14steps
~84min
3/5difficulty
02040608010049.136N·mlb·ft
Tightening torque found on this page
Done 0 of 14

Inspection

  1. Turn the ignition off.
  2. Disconnect the exhaust gas temperature sensor No. 1/No. 2 connector.
  3. Measure the resistance between the sensor signal terminal and the ground terminal.
  4. Make sure the resistance is within specification. Exhaust Gas Temperature Sensor [EGTS No. 1, No. 2 (T3, T4)]
    Temperature [°C (°F)] Resistance (kOhm)
    -40 (-40) 0,17
    0 (-32) 0,201
    100 (212) 0,276
    200 (392) 0,35
    300 (572) 0,42
    400 (752) 0,489
    500 (932) 0,555
    600 (1112) 0,618
    700 (1292) 0,68
    800 (1472) 0,739
    850 (1562) 0,767

Removal

[EGTS No. 1]
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Raise the vehicle.
  3. Remove the side cover.
  4. Disconnect the EGTS connector (A).
  5. Remove the EGTS (B).
  6. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  7. Raise the vehicle.
  8. Remove the side cover.
  9. Disconnect the EGTS connector (A).
  10. Remove the EGTS (B).
[EGTS No. 2]

Installation

  1. Install in the reverse order of removal. Exhaust Gas Temperature Sensor (EGTS): 39.2–49 N·m

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.