Hyundai Kona Quiz
Engine Control System/Fuel System

Crankshaft Position Sensor (CKPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
4steps
~24min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Inspection

  1. Check the CKPS and CMPS signal waveform using the GDS.

    Specification: Refer to "Waveform"

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Disconnect the crankshaft position sensor connector (A).
  3. Remove the engine room cover. (Refer to Engine Mechanical System - "Engine Room Cover")
  4. Remove the crankshaft position sensor (A) after loosening the mounting bolts.

Installation

  1. Install in the reverse order of removal. Crankshaft position sensor mounting bolt: 7.8–11.8 N·m

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.