Hyundai Kona Quiz
Engine Control System/Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAP sensor output voltage at idle and with the ignition ON.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Disconnect the MAP sensor connector (A).
  3. Remove the installation bolt (B) and remove the sensor from the surge tank.

Installation

  1. Install in the reverse order of removal. Manifold absolute pressure sensor mounting bolt: 9.8–11.8 N·m

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.