Engine Control/Fuel System

Accelerator Position Sensor (APS) Repair procedures

6steps
~36min
2/5difficulty
0102030405015.712N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Inspection

  1. Connect the KDS/GDS on the Data Link Connector (DLC).

  2. Switch "ON" the ignition.

  3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

    Accelerator
    Position
    Output Voltage (V) [Vref = 5V]
    APS1 APS2
    C.T 0.7 - 0.8 0.33 - 0.43
    W.O.T 3.98 - 4.22 1.98 - 2.13

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Disconnect the accelerator position sensor connector (A).

  3. Remove the accelerator position sensor after loosening the mounting nuts (A).

    Accelerator pedal sensor mounting bolt :

    12.7 - 15,7 N·m

Installation

  1. Install in the reverse order of removal.