Engine Control/Fuel System

Electric EGR Control Valve Repair procedures

11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

[Motor]

  1. Switch "OFF" the ignition.

  2. Disconnect the EEGR valve connector.

  3. Check if the EEGR valve is stuck by foreign material.

  4. Measure the resistance between 1 and 3 control terminals of the motor.

  5. Check that the resistance is within the specification.

    Specification : 2.21 - 2.99 Ω [20 °C]

[Feedback Position Sensor]

  1. Connect the KDS/GDS to the data link connector.

  2. Fully open and fully close the EEGR valve by conducting the actuation test.

  3. Check that the voltage is within the specification

    Item Specification
    Sensor Power (V) 5
    Pin 3
    Closed Voltage (V) 3.85 - 4.15
    Open Voltage (V) 0.75 - 1.25

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. EGR cooler pipe.

    (Refer to Engine Mechanical System - "EGR Cooler")

  3. Remove the EEGR valve (B) after loosening the mounting bolts and nuts (A).

Installation

  1. Install in the reverse order of removal.