Engine Control/Fuel System

Intake Air Temperature Sensor (IATS) Repair procedures

7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Switch "OFF" the ignition.

  2. Disconnect the IATS connector.

  3. Measure resistance between the IATS terminals 3 and 4.

  4. Check that the resistance is within the specification.

    Temperature Resistance (kΩ)
    °C °F
    -40 -40 40.93 - 48.35
    -20 -4 13.89 - 16.03
    0 32 5.38 - 6.09
    10 50 3.48 - 3.90
    20 68 2.31 - 2.57
    40 104 1.08 - 1.21
    60 140 0.54 - 0.62
    80 176 0.29 - 0.34

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Disconnect the intake air temperature sensor connector (A).

  3. Remove the sensor (B) after loosening the mounting bolt from the intake manifold.

    Manifold absolute pressure sensor mounting bolt:

    9.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.