Engine Control/Fuel System

ETC (Electronic Throttle Control) System Repair procedures

24steps
~144min
4/5difficulty
010203040509.87N·mlb·ft
Tightening torque found on this page
Done 0 of 24

Inspection

Throttle Position Sensor (TPS)

  1. Connect the KDS/GDS on the Data Link Connector (DLC).

  2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

    [Throttle Position Sensor (TPS)]

    Throttle angle(°) Output Voltage (V) [Vref=5V]
    TPS1 TPS2
    0 0.5 4.5
    10 0.96 4.05
    20 1.41 3.59
    30 1.87 3.14
    40 2.32 2.68
    50 2.78 2.23
    60 3.23 1.77
    70 3.69 1.32
    80 4.14 0.86
    90 4.6 0.41
    98 4.65 0.35
    C.T (0) 0.5 4.5
    W.O.T (86) 4.41 0.59

ETC Motor

  1. Switch "OFF" the ignition.

  2. Disconnect the ETC module connector.

  3. Measure resistance between the ETC module terminals 1 and 2.

  4. Check that the resistance is within the specification.

    Specification: 0.3 - 100 Ω [20 °C]

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the air cleaner.

    (Refer to Engine Mechanical System - “Air Cleaner”)

  3. Disconnect the ETC module connector (A).

  4. Remove the installation bolts, and then remove the ETC module (B) from the engine.

    Electronic throttle body mounting bolt:

    7.8 - 9,8 N·m

Installation

  1. Install in the reverse order of removal.

Adjustment

ETC module learning procedure

Be sure to perform the ETC module learning procedure when replacing or re-installing the ETC module.

  1. Wait for one minute with the ignition switched "ON".

  2. Start and keep the engine idle for 15 minutes.

  3. Wait for one minute with the ignition switched "OFF".

  4. Restart the engine, and check that the idle speed is stable.

Auto Dection Reset Procedure

  1. Switch "OFF" the ignition.

  2. Connect the KDS/GDS to Data Link Connector (DLC).

  3. Switch "ON" the ignition.

  4. Select "Vehicle, Model year, Engine, System".

  5. Select "Vehicle S/W Management".

  6. Select "ECM Auto Detection Reset".

Cleaning

  1. Remove the ETC module.

    (Refer to Engine Control System - "ETC System")

  2. Keep the ETC module plate (A) open.

  3. Clean the pollutant in the throttle body with a soft cloth moistened by cleaning fluid.

  4. After cleaning, reinstall the ETC module and then perform the ETC module learning procedure.

    (Refer to Engine Control System - "ETC System" - Adjustment)