Engine Control/Fuel System

Mass Air Flow Sensor (MAFS) Repair procedures

5steps
~30min
2/5difficulty
010203040505.84N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Visually check the MAFS for the following:

    • Correct mounting direction

    • Any contamination, corrosion or damage on connector

    • Clogged or wet air cleaner

    • Deformation or blocked MAFS cylinder by foreign material

  2. Check for any leakage on intake system and intercooler system.

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Disconnect the mass air flow sensor connector (A) and the installation clamp (B).

  3. Remove the mass air flow sensor (C).

    Mass air flow sensor mounting bolt :

    3.9 - 5,8 N·m

    Mass air flow sensor clamp mounting screw :

    2.9 - 4,9 N·m

Installation

  1. Install in the reverse order of removal.