Engine Control/Fuel System

Engine Coolant Temperature Sensor (ECTS) Repair procedures

15steps
~90min
4/5difficulty
Done 0 of 15

Inspection

  1. Switch "OFF" the ignition.

  2. Remove the ECTS (Refer to "Removal").

  3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 1 and 2.

  4. Check that the resistance is within the specification.

    Temperature Resistance (kΩ)
    °C °F
    -40 -40 48.14
    -20 -4 14.13 - 16.83
    0 32 5.79
    20 68 2.31 - 2.59
    40 104 1.15
    60 140 0.59
    80 176 0.32

Removal

Engine Coolant Temperature Sensor (ECTS) [Water Temperature Control Assembly]

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Remove the purge control solenoid valve.

    (Refer to Engine Control / Fuel System - "Purge Control Solenoid Valve (PCSV)")

  4. Disconnect the engine coolant temperature sensor connector (A).

  5. Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.

Engine Coolant Temperature Sensor (ECTS) [EGR Cooler Tube]

  1. Turn the ignition switch OFF and disconnect the battery (-) terminal.

  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the engine coolant temperature sensor connector (A).

  4. Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.

Installation

  1. Install in the reverse order of removal.

  2. Replenish the engine coolant.

    (Refer to Engine Mechanical System - “Coolant”)