Engine Control/Fuel System

Crankshaft Position Sensor (CKPS) Repair procedures

5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Check signal waveform of CKPS and CMPS using a KDS/GDS.

    Specification: Refer to “Waveform”

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the air cleaner.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the crankshaft position sensor connector (A).

  4. Remove the engine room under cover.

    (Refer to Engine Mechanical System - "Engine Room Under Cover")

  5. Remove the crankshaft position sensor after loosening the mounting bolt (A).

    Crankshaft position sensor mounting bolt :

    9.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.