Engine Control/Fuel System

Purge Control Solenoid Valve (PCSV) Repair procedures

9steps
~54min
2/5difficulty
Done 0 of 9

Inspection

  1. Switch "OFF" the ignition.

  2. Disconnect the PCSV connector.

  3. Measure resistance between the PCSV terminals 1 and 2.

  4. Check that the resistance is within the specification.

    Specification: 14.3 - 14.7 Ω [20 °C]

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the purge control solenoid valve connector (A).

  4. Disconnect the vapor hoses (B) from the purge control solenoid valve.

  5. Remove the purge control solenoid valve.

Installation

  1. Install in the reverse order of removal.