Engine Control/Fuel System

Knock Sensor (KS) Repair procedures

3steps
~18min
2/5difficulty
0102030405023.517N·mlb·ft
Tightening torque found on this page
Done 0 of 3

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the intake manifold. (Refer to Engine Mechanical System - “Intanke Manifold”)

  3. Remove the installation bolt (A), and then remove the sensor from the cylinder block.

    Knock sensor mounting bolt:

    18.6 - 24 N·m

Installation

  1. Install in the reverse order of removal.