Engine Control/Fuel System

Rail Pressure Sensor (RPS) Repair procedures

7steps
~42min
2/5difficulty
02040608010034.325N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Connect the KDS/GDS on the Data Link Connector (DLC).

  2. Measure the output voltage of the RPS during idle at various engine speeds.

    Pressure Output Voltage (V) [Vref=5V]
    bar [MPa (kgf/cm², psi)]
    0 0 (0, 0) 0.5
    140 14 (142, 2031) 2.5
    280 28 (286, 4061) 4.5

Removal

  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”).

  2. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  3. Remove the intake manifold.

    (Refer to Engine Mechanical System - "Intake Manifold")

  4. Remove the injector foam.

  5. Disconnect the rail pressure sensor connector, and then remove the sensor (A) from the delivery pipe.

    Rail Pressure Sensor : 30.0 - 34 N·m

Installation

  1. Install in the reverse order of removal.