Engine Control/Fuel System

Camshaft Position Sensor (CMPS) Repair procedures

7steps
~42min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

  1. Check the signal waveform of the CMPS and CKPS using the KDS/GDS.

    Specification: Refer to “Wave Form”

Removal

[Bank 1 / Intake]

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Remove the air cleaner.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the camshaft position sensor connector (A).

  4. Remove the camshaft position sensor after loonsening the mounting bolt (B).

    Camshaft position sensor mounting bolt:

    7.8 - 11,8 N·m

[Bank 1 / Exhaust]

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Disconnect the camshaft position sensor connector (A).

  3. Remove the camshaft position sensor after loonsening the mounting bolt (B).

    Camshaft position sensor mounting bolt:

    7.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.