Engine Control/Fuel System

Manifold Absolute Pressure Sensor (MAPS) Repair procedures

5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the KDS/GDS on the Data Link Connector (DLC).

  2. Measure the output voltage of the MAPS during idle with IG ON.

    Pressure
    [kPa (kgf/cm², psi)]
    Output Voltage (V) [Vref = 5V]
    20.0 (0.20, 2.9) 0.79
    46.7 (0.47, 6.77) 1.84
    101.3 (1.03, 14.7) 4.0

Removal

  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

  2. Disconnect the manifold absolute pressure sensor connector (A).

  3. Remove the sensor (B) after loosening the mounting bolt from the intake manifold.

    Manifold absolute pressure sensor mounting bolt:

    9.8 - 11,8 N·m

Installation

  1. Install in the reverse order of removal.