Kia Stonic Quiz
Engine Control System/Fuel System

Kraftstoffleitung

In this manual: Engine Control System/Fuel System
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
14steps
~94min
5/5difficulty
2special tools
0102030405032.424N·mlb·ft
Tightening torque found on this page
Done 0 of 14

repair procedures

expansion

Low Pressure Fuel Hose

  1. Release the residual pressure in the fuel line.

    (See Fuel Supply - "Relieving Residual Pressure in the Fuel Line")

  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  3. Disconnect the quick connector (A) from the filler hose and the vent hose (B).

  4. Remove the air filter.

    (Refer to Engine Mechanical - "Air Cleaner").

  5. Remove the fuel tank.

    (Refer to Fuel System - "Fuel Tank")

  6. Loosen the mounting screws and nuts, then remove the cover under [LH].

  7. Loosen the mounting bolts and bracket, then remove the fuel line (A).

HIGH PRESSURE FUEL LINE

  1. Release the residual pressure in the fuel line.

    (Refer to Fuel System - "Relieve Fuel Pressure from Fuel Line").

  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  3. Remove the air filter housing and the intake hose.

    (Refer to Engine Mechanical - "Air Cleaner").

  4. Remove the engine control wiring.

  5. Remove the vacuum line (A).

  6. Remove the flare nut of the high pressure line (B) using the following Special Service Tool [SST No.: 09314-3Q100 or 09314-27130].

    High Pressure Fuel Line Flare Nut: 26.5 ~ 32 N·m

  7. Remove the flare nut (A) of the supply line using the following Special Service Tool (B) [SST No.: 09314-3Q100 or 09314-27130].

    High Pressure Fuel Line Flare Nut: 26.5 ~ 32 N·m

8th.

Loosen the mounting screw, then remove and disconnect the functional unit. Remove the high pressure fuel line (A).

High Pressure Fuel Line Mounting Screw, Functional Unit:

9,8~11.8 N·m

Installation

  1. Installation is the reverse of removal.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.