Kia Cee'd Quiz
Fuel System

Accelerator Position Sensor (APS) Repair Procedures

In this manual: Fuel System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
6steps
~36min
2/5difficulty
0102030405019.715N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Turn the ignition on.
  3. Measure the output voltage of APS 1 and 2 at C.T. and W.O.T.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the mounting bolt (B) and nuts (C), then remove the accelerator pedal module.

Installation

  1. Installation is the reverse of removal. Accelerator pedal module nut: 12.7 ~ 19.7 N·m Accelerator pedal module bolt: 8.8 ~ 13.7 N·m

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.