Kia Cee'd Quiz
Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Fuel System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAP sensor output voltage at idle and with the ignition ON.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Disconnect the MAP sensor connector (A).
  3. Remove the installation bolt (B) and remove the sensor from the surge tank.

Installation

  1. Installation is the reverse of removal. MAP Sensor Mounting Bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.