Kia Cee'd Quiz
Fuel System

Rail Pressure Sensor (RPS) Repair Procedures

In this manual: Fuel System
General Information — 15Maintenance — 7Engine Mechanical System — 84Engine Electrical System — 49Emission Control System — 22Fuel System — 95Clutch System — 28Manual Transmission — 21Dual Clutch Transmission (DCT) System — 47Drive Shaft and Axle — 20Suspension System — 36Steering — 23Restraints — 39Brake System — 54Body (Interior and Exterior) — 209Body Electrical System — 254Heating, Ventilation, and Air Conditioning — 56
6steps
~36min
3/5difficulty
02040608010034.325N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the RPS output voltage at idle and at various engine speeds.
    Condition Output voltage (V)
    Idle approx. 1.2
    1500 rpm 2,2 ~ 2,5
    6300 rpm approx. 3.0

Removal

  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Release the residual fuel pressure in the fuel line. (Refer to Fuel System - "Release Residual Fuel Pressure in Line")
  3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")
  4. Disconnect the rail pressure sensor connector (A), then remove the sensor (B) from the fuel rail.

Installation

  1. Installation is the reverse of removal. Rail Pressure Sensor installation: 29.4 ~ 34 N·m

Test yourself

A quick Kia Cee'd quiz: every answer comes with an explanation and a link to the manual page.