Body Exterior, Doors, Roof & Vehicle Security

B210b Str Cont Rly on Circ

6steps
~36min
2/5difficulty
Done 0 of 6
DTC Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N (Neutral) or P (Park) position. It is installed in parallel with the starter relay.

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B210B

START CONT RLY ON CIRC

(Starter control relay on circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold

IPDM E/R detects that the relay is stuck at ON position even if the following conditions are met for about 1 second:

  • Starter control relay ON/OFF signal from BCM

  • Transmission range switch input signal

Diagnosis delay time —

POSSIBLE CAUSE

  • IPDM E/R

  • Harness or connector

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Place power supply position to start under the following conditions and wait for at least 1 second:

    • CVT selector lever is in the P (Park) or N (Neutral) position.

    • Depress the brake pedal.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

INSPECTION START

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

  3. Touch “ERASE”.

  4. Perform DTC Confirmation Procedure. Refer to DTC Confirmation Procedure.

Is DTC detected?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Inspection End.