Body Exterior, Doors, Roof & Vehicle Security
B2560 Starter Cont Relay
In this manual: Body Exterior, Doors, Roof & Vehicle Security
3steps
~18min
2/5difficulty
Done 0 of 3
Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N (Neutral) or P (Park) position.
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B2560 | STARTER CONT RELAY (Starter control relay) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | BCM detects a mismatch between the OFF request of starter control relay to IPDM E/R and the feedback. (The feedback is ON instead of OFF) | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
IPDM E/R
FAIL-SAFE
Inhibit engine cranking
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON under the following conditions and wait for at least 2 seconds:
CVT selector lever is in the P (Park) position.
Depress the brake pedal.
Select “Self Diagnosis Result” mode of “BCM”.
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO>>Inspection End.
CHECK DTC WITH IPDM E/R
CONSULT
Select “Self Diagnostic Result” mode of "BCM". Refer to DTC Index.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace malfunctioning parts.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>Inspection End.
Was this page helpful?