Body Exterior, Doors, Roof & Vehicle Security

P1610 Lock Mode

10steps
~60min
3/5difficulty
Done 0 of 10
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
P1610

LOCK MODE

(Lock mode)
Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold When ECM detects a communication malfunction between ECM and BCM 5 times or more
Diagnosis delay time —

POSSIBLE CAUSE

—

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “ENGINE”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

CHECK ENGINE START FUNCTION

CONSULT

  1. Check that there are no DTC’s except for DTC P1610 detected.

    If detected, erase the DTC after fixing.

  2. Ignition switch OFF.

  3. Contact the registered Intelligent Key backside to ignition switch and wait 5 seconds.

  4. Ignition switch ON.

  5. Ignition switch OFF and wait 5 seconds.

  6. Repeat steps 3 and 5 twice (a total of 3 times).

  7. Check that engine can start.

>>

Inspection End.