Body Exterior, Doors, Roof & Vehicle Security

B210d Starter Rly on Circ

6steps
~36min
2/5difficulty
Done 0 of 6
DTC Description

Located in IPDM E/R, the starter relay runs the starter motor. The starter relay is turned ON by the BCM when ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B210D

STARTER RLY ON CIRC

(Starter relay on circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal) IPDM E/R terminal 3
Threshold

IPDM E/R detects that the relay is stuck at ON position even if the following conditions are met for about 1 second:

  • Starter control relay ON/OFF signal from BCM

  • Transmission range switch input

Diagnosis delay time —

POSSIBLE CAUSE

  • IPDM E/R

  • Harness or connector

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON under the following conditions and wait for at least 1 second:

    • CVT selector lever is in the P (Park) or N (Neutral) position.

    • Do not depress the brake pedal.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

CHECK STARTER RELAY POWER SUPPLY CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R harness connector.

  3. Check voltage between IPDM E/R harness connector and ground.

    (+)(–)

    Voltage

    (Approx.)
    IPDM E/R
    ConnectorTerminal
    E120 3 Ground Battery voltage

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Check harness for open or short between IPDM E/R and battery.