Body Exterior, Doors, Roof & Vehicle Security
P1612 Chain of Ecm-Immu
In this manual: Body Exterior, Doors, Roof & Vehicle Security
3steps
~18min
2/5difficulty
Done 0 of 3
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| P1612 | CHAIN OF ECM-IMMU (Chain of engine control module - immobilizer unit) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | — | ||
| Threshold | Inactive communication between BCM and ECM | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
ECM
Harness or connector
(The CAN communication line is open or shorted.)
BCM
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “ENGINE”.
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO>>Inspection End.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT.
Check BCM power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the harness.
CHECK ECM POWER SUPPLY AND GROUND CIRCUIT.
Check ECM power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the harness.
PERFORM DTC CONFIRMATION PROCEDURE.
Perform the DTC confirmation procedure. Refer to DTC Confirmation Procedure.
Does the DTC return?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?