Body Exterior, Doors, Roof & Vehicle Security

Hood Switch

11steps
~66min
3/5difficulty
Done 0 of 11
Component Function Check

CHECK FUNCTION

CONSULT

  1. Select “HOOD SW” and “HOOD SW 2” in “Data Monitor” mode of “IPDM E/R”.

  2. Check “HOOD SW” and “HOOD SW 2” indication under the following condition:

Monitor itemConditionIndication
HOOD SW Hood Open OFF
Close ON
HOOD SW 2 Open ON
Close OFF

Is the indication normal?

YES>>

Hood switch is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK HOOD SWITCH SIGNAL CIRCUITS

  1. Ignition switch OFF.

  2. Disconnect hood switch connector.

  3. Check voltage between hood switch harness connector and ground.

(+)(–)

Voltage

(Approx.)
Hood switch
ConnectorTerminal
E205 1 Ground Battery voltage
2

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK HOOD SWITCH SIGNAL CIRCUITS

  1. Disconnect IPDM E/R connector.

  2. Check continuity between IPDM E/R harness connector and hood switch harness connector.

    IPDM E/RHood switchContinuity
    ConnectorTerminalConnectorTerminal
    E218 94 E205 1 Yes
    96 2
  3. Check continuity between IPDM E/R harness connector and ground.

    IPDM E/R Ground Continuity
    Connector Terminal
    E218 94 No
    96

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair or replace harness.

CHECK HOOD SWITCH GROUND CIRCUIT

Check continuity between hood switch harness connector and ground.

Hood switch Ground Continuity
Connector Terminal
E205 3 Yes

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness.

CHECK HOOD SWITCH

Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Replace hood switch. Refer to Removal and Installation.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.

Component Inspection

CHECK HOOD SWITCH

  1. Ignition switch OFF.

  2. Disconnect hood switch connector.

  3. Check continuity between hood switch terminals.

    Hood switchConditionContinuity
    Terminal
    1 3 Hood switch Press Yes
    Release No
    2 Press No
    Release Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace hood switch. Refer to Removal and Installation.