Body Exterior, Doors, Roof & Vehicle Security
B26f3 Start Cont Rly on
In this manual: Body Exterior, Doors, Roof & Vehicle Security
4steps
~24min
2/5difficulty
Done 0 of 4
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B26F3 | START CONT RLY ON (Starter control relay ON) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | BCM requests IPDM E/R to turn starter control relay OFF, but BCM cannot receive starter control relay OFF state signal from IPDM E/R (CAN) | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
IPDM E/R
Harness or connector
(The CAN communication line is open or shorted.)
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch under the following conditions to start engine:
Shift selector lever: In the P (Park) position.
Brake pedal: Depressed.
Wait 2 seconds after engine started.
Select “Self Diagnostic Result” mode of “BCM”.
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO>>Inspection End.
CHECK DTC OF IPDM E/R
CONSULT
Select “Self Diagnostic Result” mode of “IPDM E/R”.
Is DTC detected?
YES>>Perform the diagnosis procedure related to the detected DTC. Refer to DTC Index.
NO>>GO TO 2.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>Inspection End.
Was this page helpful?