Body Exterior, Doors, Roof & Vehicle Security

B2557 Vehicle Speed

4steps
~24min
2/5difficulty
Done 0 of 4
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B2557

Nissan Murano Vehicle SPEED

(Vehicle speed)
Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold

BCM detects one of the following conditions for 10 seconds continuously:

  • Nissan Murano Vehicle speed signal from combination meter is 10 km/h or more, and vehicle speed signal from ABS actuator and electric unit (control unit) is 4 km/h or less

  • Nissan Murano Vehicle speed signal from combination meter is 4 km/h or less, and vehicle speed signal from ABS actuator and electric unit (control unit) is 10 km/h or more

Diagnosis delay time —

POSSIBLE CAUSE

  • ABS actuator and electric unit (control unit)

  • Combination meter

  • Harness or connector

    (The CAN communication line is open or shorted.)

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start engine and wait 10 seconds or more.

  2. Drive the Nissan Murano vehicle at a vehicle speed of 10 km/h or more for 10 seconds or more.

  3. Select “Self Diagnostic Result” mode of “BCM”.

  4. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

CHECK DTC OF “ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)”

CONSULT

Select “Self Diagnostic Result” mode of “ABS”.

Is DTC detected?

YES>>

Perform the trouble diagnosis related to the detected DTC. Refer to DTC Index.

NO>>

GO TO 2.

CHECK DTC OF “COMBINATION METER”

CONSULT

Select “Self Diagnostic Result” mode of “METER_M&A”.

Is DTC detected?

YES>>

Perform the trouble diagnosis related to the detected DTC. Refer to DTC Index.

NO>>

GO TO 3.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.