Body Exterior, Doors, Roof & Vehicle Security

B2196 Dongle Ng

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

BCM performs ID verification between BCM and dongle unit.

When verification result is OK, BCM permits cranking.

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B2196

DONGLE NG

(Dongle unit not good)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold The ID verification results between BCM and dongle unit is not good
Diagnosis delay time —

POSSIBLE CAUSE

  • Dongle unit

  • Harness or connector

    (Dongle unit circuit is open or shorted.)

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnosis Result” mode of “BCM”.

  3. Check DTC.

Is the DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

PERFORM INITIALIZATION

  1. Perform initialization of BCM and reregistration of all Intelligent Keys. Refer to Work Procedure.

  2. Start the engine.

Does the engine start?

YES>>

Inspection End.

NO>>

GO TO 2.

CHECK DONGLE UNIT CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect BCM connector and dongle unit connector.

  3. Check continuity between BCM harness connector and dongle unit harness connector.

    BCMDongle unitContinuity
    ConnectorTerminalConnectorTerminal
    M19 52 M29 1 Yes
  4. Check continuity between BCM harness connector and ground.

    BCM Ground Continuity
    Connector Terminal
    M19 52 No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK DONGLE UNIT GROUND CIRCUIT

Check continuity between dongle unit harness connector and ground.

Dongle unit Ground Continuity
Connector Terminal
M29 4 Yes

Is the inspection result normal?

YES>>

Replace dongle unit. Refer to Removal and Installation.

NO>>

Repair or replace harness.