Meters / Gauges / Display

Steering Pad Switch Circuit

~2min read

DESCRIPTION

The meter assembly and the steering switch assembly are connected via a dedicated line. The main display and multi-information display of the meter assembly are operated using the switches on the steering switch assembly.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the instrument cluster assembly, always use a new part. If an instrument cluster assembly that was installed in another vehicle is used, the stored information will not match the information transmitted by the vehicle, and a DTC may be stored.

PROCEDURE

  1. CHECK STEERING PAD SWITCH ASSEMBLY

(a) Remove the steering pad switch assembly.

Click here

(b) Check the steering pad switch assembly.

Click here

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

OK
  1. CHECK SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

(a) Remove the spiral cable with sensor sub-assembly.

Click here

(b) Check the spiral cable with sensor sub-assembly.

Click here

NG

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

OK
  1. INSPECT WIRE HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR - METER ASSEMBLY)

(a) Disconnect the connector from the combination meter assembly F4.

(b) Disconnect the F29 connector from the spiral cable sub-assembly with sensor.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F4-28 (MSM+) - F29-10 (+DP)

Always

Below 1 Ω

F4-33 (MSSL) - F29-11 (+DP2)

Always

Below 1 Ω

F29-3 (EAU) - Body ground

Always

Below 1 Ω

F4-28 (MSM+) - Body ground

Always

10 kΩ minimum

F4-33 (MSSL) - Body ground

Always

10 kΩ minimum

OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR