Meters / Gauges / Display

Instrument cluster does not operate at all

~1min read

DESCRIPTION

This circuit is the power supply circuit of the combination meter assembly. This circuit provides two types of power source: one is a constant power source and the other is an IG power source.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Check the fuses for the circuits related to this system before performing the following procedure.
  • When replacing the instrument cluster assembly, always use a new part. If an instrument cluster assembly that was installed in another vehicle is used, the stored information will not match the information transmitted by the vehicle, and a DTC may be stored.

PROCEDURE

  1. INSPECT WIRE HARNESS AND CONNECTOR (COMBINATION METER ASSY CIRCUIT)

(a) Disconnect the connector from the combination meter assembly F4.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F4-21 (ET) - Body Ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F4-39 (IG+) - Body Ground

Ignition Switch in OFF position

Below 1 V

Ignition Switch in ON position

11 à 14 V

F4-40 (B) - Body Ground

Always

11 à 14 V

OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR