Meters / Gauges / Display

ECU Terminals

~11min read

ECU TERMINALS

COMBINATION METER ASSEMBLY

(a) Disconnect the connectors from the instrument cluster assembly.

(b) Measure the voltage of the connector on the wire harness side according to the value(s) in the table below.

Terminal No.

Wire Color

Terminal Description

Condition

Specified Condition

F4-39 (IG+) - Body Ground

P - Body ground

Ignition switch signal

Ignition Switch in OFF position

Below 1 V

Ignition Switch in ON position

11 à 14 V

F4-40 (B) - Body Ground

SB - Body ground

Battery

Always

11 à 14 V

F5-1 (B) - Body ground

SB - Body ground

Battery

Always

11 à 14 V

If the result is not as specified, there may be a malfunction in the wire harness.

(c) Reconnect the connectors to the instrument cluster assembly.

(d) Measure the voltage and resistance according to the values shown in the table below.

Terminal No. (Symbol)

Wire Color

Terminal Description

Condition

Specified Condition

F4-1 (RLMT) - Body ground*1

L - Body ground

Rear LH Seat Belt Reminder Light Signal

Rear left seat belt buckled within 30 seconds after opening the rear door with the ignition switch ON

11 à 14 V

Rear left seat belt not buckled within 30 seconds after opening the rear door with the ignition switch ON

Below 1 V

F4-2 (RCMT) - Body ground*1

V - Body ground

Rear center seat belt reminder signal

Rear center seat belt buckled within 30 seconds after opening the rear door with the ignition switch ON

11 à 14 V

Rear center seat belt not buckled within 30 seconds after opening the rear door with the ignition switch ON

Below 1 V

F4-3 (RRMT) - Body ground*1

W - Body Ground

Rear RH Seat Belt Reminder Light Signal

Rear right seat belt buckled within 30 seconds after opening the rear door with the ignition switch ON

11 à 14 V

Rear right seat belt not buckled within 30 seconds after opening the rear door with the ignition switch ON

Below 1 V

F4-4 (INT) - Body ground*2

B - Body ground

Low tire pressure warning light signal

Ignition switch ON, low tire pressure warning light OFF

Below 1 V

Ignition switch ON, low tire pressure warning light ON

11 à 14 V

F4-5 (SI) - Body ground

GR - Body ground

Vehicle speed signal from another system (input)

Ignition switch ON, steering wheel turned

Pulse generation (see waveform 1)

F4-6 (+S) - Body ground

V - Body ground

Speed signal from other system (output)

Ignition switch ON, steering wheel turned

Pulse generation (see waveform 1)

F4-7 (PKBI-) - Body ground*3

GR - Body ground

Front passenger seat belt buckle switch signal

Ignition switch ON, front passenger seat belt buckled and front passenger seat occupied

11 à 14 V

Ignition switch ON, front passenger seat belt not buckled and front passenger seat occupied

Below 1 V

F4-9 (S) - Body ground

G - Body ground

Engine oil pressure switch signal

Ignition switch ON, engine oil level warning light ON

Below 1 V

Ignition switch ON, engine oil level warning light OFF

11 à 14 V

F4-10 (MSD) - Body ground*1

V - Body ground

Rear seat belt inner belt signal (left side)

Ignition switch ON, rear left seat belt not buckled

Below 1 V

Ignition switch ON, rear left seat belt buckled

11 à 14 V

F4-11 (MSTI) - Body ground*1

BE - Body ground

Rear seat belt inner belt signal (center)

Ignition switch ON, rear center seat belt not buckled

Below 1 V

Ignition switch ON, rear center seat belt buckled

11 à 14 V

F4-12 (SW) - Body ground

R - Body ground

Brake System Warning Light Signal (Red Light)

Ignition switch ON, brake system warning light (red) ON

Below 1 V

Ignition switch ON, brake system warning light (red) OFF

11 à 14 V

F4-13 (MSFM) - Body ground*1

R - Body ground

Rear right seat belt inner signal (right side)

Ignition switch ON, rear right seat belt not fastened

Below 1 V

Ignition switch ON, rear right seat belt fastened

11 à 14 V

F4-16 (FV) - Body ground

GR - Body ground

Fuel level sensor (power supply)

Fuel level F (full) → E (empty)

4,5 à 5,5 V

F4-17 (WLVL) - Body ground*4

LG - Body ground

Washer fluid level signal

Ignition switch ON, washer fluid level not low

11 à 14 V

Ignition switch ON, washer fluid level low

Below 1 V

F4-20 (SW3) - Body ground

W - Body Ground

Light control rheostat switch ground

Always

Below 1 Ω

F4-21 (ET) - Body Ground

W-B - Body ground

Ground

Always

Below 1 Ω

F4-23 (FR) - F4-15 (FE&B)

G - BE

Fuel level signal

Ignition switch ON, fuel level at maximum

Below 1 V

Ignition switch ON, fuel level low (fuel level warning light on)

4,5 à 9 V

F4-24 (TC) - Body ground

V - Body ground

TAIL cut-off switch signal

TAIL cut-off switch OFF → ON

10 kΩ or higher → Below 1 Ω

F4-25 (SW1) - Body ground

G - Body ground

Light control rheostat power supply

Ignition Switch in ON position

4,6 à 5,4 V

F4-26 (SW2) - Body ground

L - Body ground

Light control rheostat knob input

Light control rheostat knob turned fully down

Below 1 Ω

Light control rheostat knob turned fully up

10 kΩ minimum

F4-28 (MSM+) - Body ground

V - Body ground

Steering wheel switch signal

Ignition switch ON, Enter, trip meter and rear switches on steering wheel switch not pressed

4,3 à 5,2 V

Ignition switch ON, Enter switch on steering wheel switch pressed

Below 0.6 V

Ignition switch ON, trip meter switch on steering wheel switch pressed

1,0 à 2,2 V

Ignition switch ON, rear switch on steering wheel switch pressed

2,3 à 3,4 V

F4-31 (CANL) - Body ground

SB - Body ground

CAN communication line

-

-

F4-32 (CANH) - Body ground

V - Body ground

CAN communication line

-

-

F4-33 (MSSL) - Body ground

GR - Body ground

Steering wheel switch signal

Ignition switch ON, up, down, right and left switches on steering wheel switch assembly not pressed

4,3 à 5,2 V

Ignition switch ON, left switch on steering wheel switch pressed

Below 0.6 V

Ignition switch ON, up switch on steering wheel switch pressed

1,0 à 2,2 V

Ignition switch ON, down switch on steering wheel switch pressed

2,3 à 3,4 V

Ignition switch ON, right switch on steering wheel switch pressed

3,4 à 4,5 V

F4-34 (TEMP) - Body ground

SB - Body ground

Ambient temperature sensor signal

Ambient temperature 25 °C

1,6 à 1,8 Ω

F4-35 (TX1+) - Body ground

P - Body ground

Ambient temperature sensor gauge signal

Always

Below 1 Ω

F5-2 (VCM) - Body ground*5

GR - Body ground

Vacuum reminder switch signal

Ignition switch ON, engine idle speed

Pulse generation

F5-3 (HAZ) - Body ground

W - Body Ground

Hazard warning switch output signal

Hazard warning signal switch in OFF position

11 à 14 V

Hazard warning signal switch in ON position

Below 1 V

F5-5 (TRNR) - Body ground

SB - Body ground

Rear right turn signal

Ignition switch ON, right turn signal indicator off

Below 1 V

Ignition switch ON, right turn signal indicator flashing

11 to 14 V ←→ Below 1 V

F5-6 (TRNL) - Body ground

Y - Body Ground

Rear left turn signal

Ignition switch ON, left turn signal indicator off

Below 1 V

Ignition switch ON, left turn signal indicator flashing

11 to 14 V ←→ Below 1 V

F5-7 (LR) - Body ground

V - Body ground

Rear right turn signal

Ignition switch ON, right turn signal indicator off

Below 1 V

Ignition switch ON, right turn signal indicator flashing

11 to 14 V ←→ Below 1 V

F5-8 (SW) - Body ground

L - Body ground

Turn signal switch signal (full turn)

High/low beam switch ON (full turn)

Below 1 V

High/low beam switch OFF

11 à 14 V

F5-9 (ER) - Body ground

P - Body ground

Right turn signal (input)

Ignition switch ON, right turn switch on

Below 1 V

Ignition switch ON, right turn switch off

11 à 14 V

F5-10 (EL) - Body ground

B - Body ground

Left turn signal (input)

Ignition switch ON, left turn switch on

Below 1 V

Ignition switch ON, left turn switch off

11 à 14 V

F5-13 (LL) - Body ground

G - Body ground

Rear left turn signal

Ignition switch ON, left turn signal indicator off

Below 1 V

Ignition switch ON, left turn signal indicator flashing

11 to 14 V ←→ Below 1 V

  • *1: With rear passenger seat belt reminder
  • *2: with tire pressure detection system
  • *3: with occupant classification system
  • *4: with washer fluid level reminder switch
  • *5: with vacuum reminder switch

If the result is not as specified, there may be a malfunction in the combination meter assembly.

(1) Waveform 1 (reference):

Item

Condition

Oscilloscope Setting

5 V/DIV., 20 ms/DIV.

Vehicle Operating Conditions

Ignition switch ON, steering wheel turned

HINT:

When the system is operating normally, one wheel revolution generates 4 pulses. As vehicle speed increases, the width indicated by (A) in the diagram decreases.