Driving
Driving in vehicle-distance control mode
In this manual: Driving
3steps
~18min
2/5difficulty
Done 0 of 3
This mode uses a radar sensor to detect vehicles up to approximately 100 m (328 ft.) ahead of your vehicle, to measure the distance between your vehicle and the vehicle ahead and to keep that distance at a sufficient value.
Note that the distance between vehicles tends to decrease on long downhill slopes.

- Example of constant speed cruise
When there is no vehicle ahead
The vehicle travels at the speed set by the driver. You can also set the desired distance between vehicles using the corresponding control. - Example of deceleration and variable cruise speed
When a slower vehicle appears ahead
When a vehicle is detected ahead of yours, the system automatically reduces the vehicle speed. If further deceleration is required, the system applies the brakes (the brake lights come on at this time).The system responds to changes in the speed of the vehicle ahead in order to keep the distance between vehicles set by the driver constant.
A proximity warning alerts you when the system cannot reduce the speed sufficiently to prevent your vehicle from getting too close to the vehicle ahead.
- Example of acceleration
When no vehicle ahead is travelling slower than the set speed
The system accelerates the vehicle until it reaches the set speed. The system then returns to constant cruise control mode.
Was this page helpful?