Honda Accord Quiz
Brake System

Brake Fluid Level Switch Functional Check and Replacement

In this manual: Brake System
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

CHECK
PROCEDURE

1. Disconnect the switch electrical connector and remove the cover from the master cylinder reservoir.

2. Проверьте свободу хода поплавка датчика. В случае выявления признаков заклинивания

2. Check that the float moves freely. If signs of sticking are found, replace the assembly. Using an ohmmeter, verify there is no continuity between the switch connector terminals with the float raised, and that there is continuity with the float lowered.

3. Удостоверьтесь в наличии проводимости между клеммами разъема при опущенном

3. Verify there is continuity between the connector terminals with the float lowered.

4. If the checks fail, replace the faulty switch.

REPLACEMENT
PROCEDURE

1. Disconnect the electrical wiring from the switch.
2. Remove the cover from the master cylinder reservoir and replace it as an assembly with the switch.
3. Install in the reverse order.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.