Selector Lever Position Switch Adjustment

PROCEDURE

1. Move the selector lever to the N position.

2. Loosen the lock nut on the control lever at the cable connection to the lever.
3. Move the control lever to the N position.
4. Rotate the position switch housing by up to 12 mm and align the wide end of the control lever with the switch protrusion.

5. Tighten the switch mounting bolts to a torque of 10–12 N·m.

Take care when rotating the switch housing not to damage the O-ring.

6. Check that the selector lever is in the N position.
7. Adjust the position of the nut so that there is no cable slack and the selector lever moves smoothly.

8. Perform a road test and make sure the transmission is in the position corresponding to each selector lever position.