Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Fuel Tank Pressure Sensor (FTPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the output voltage of the FTPS.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Fold down the rear seat cushion.
  3. Remove the auxiliary fuel sensor service cover (A) after removing the installation screw.
  4. Disconnect the fuel tank pressure sensor connector (A).
  5. Remove the fuel tank pressure sensor from the auxiliary fuel sensor after loosening the nut.

Installation
  • Install the component with the specified torque.
  • Be careful not to drop the component, as internal damage may occur. If dropped, inspect it before use.
  • Insert the sensor into the mounting hole, taking care not to damage it during installation.
  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.