Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Rail Pressure Sensor (RPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
6steps
~36min
2/5difficulty
02040608010034.325N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the RPS output voltage at idle and at various engine speeds.
    Condition Output voltage (V)
    Idle approx. 1.2
    1500 rpm 2,0 ~ 2,2
    6300 rpm approx. 2.8

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Relieve the residual fuel pressure in the fuel line (refer to "Relieve Residual Fuel Pressure" in this group).
    A diagnostic trouble code (DTC) may be set when the fuel pump relay is removed. Clear the DTC with GDS after performing "Relieve Residual Fuel Pressure".
  3. Remove the intake manifold (refer to "Intake and Exhaust System" in the EM group).
  4. Disconnect the rail pressure sensor connector (A), then remove the sensor (B) from the delivery pipe.

Installation
  • Install the component with the specified torque.
  • Be careful not to drop the component, as internal damage may occur. If dropped, inspect it before installation.
  1. To install, reverse the removal procedure. Rail pressure sensor: 29.4 ~ 34 N·m

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.