Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Manifold Absolute Pressure (MAP) Sensor Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
5steps
~30min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the MAPS output voltage at idle and with the ignition switch ON.
    Condition Output voltage (V)
    IGNITION ON Approx. 4.44 V
    Idle Approx. 0.75 V

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the MAP sensor connector (A).
  3. Remove the mounting bolts (B), then remove the sensor vertically from the surge tank.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Insert the sensor into the mounting hole, taking care not to damage it during installation.
  1. To install, reverse the removal procedure. Manifold Absolute Pressure Sensor mounting bolt: 7.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.