Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Repair Procedures for Variable Intake Solenoid (VIS)

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
12steps
~72min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Inspection

  1. Turn the ignition off.
  2. Disconnect the VIS valve connector.
  3. Measure the resistance between terminals 1 and 2 of the VIS valve.
  4. Make sure the resistance is within specification.

    Specification: Refer to "Specifications"

Removal

[VIS No. 1]

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the variable intake solenoid connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the installation nut (C), then remove the valve from the surge tank.

[VIS No. 2]

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the variable intake solenoid connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the installation nut (C), then remove the valve from the surge tank.

Installation
  • Install the component with the specified torque.
  • Be careful not to drop the component, as internal damage may occur. If dropped, inspect it before installation.
  • Be careful not to allow foreign material to enter the valve.
  1. To install, reverse the removal procedure. Variable intake solenoid valve mounting nut: 7.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.