Canister Close Valve (CCV) Repair Procedures

Inspection

1. 1
   Turn the ignition off.
2. 2
   Disconnect the CCV connector.
3. 3
   Measure the resistance between terminals 1 and 2 of the CCV.
4. 4
   Make sure the resistance is within specification.

   Specifications: Refer to the Specifications section.

5. 5
   Disconnect the vapor hose connected to the canister from the CCV.
6. 6
   Connect a vacuum pump to the nipple.
7. 7
   Ground the CCV control line and apply battery voltage to the CCV power line.
8. 8
   Create a vacuum and check valve operation.

   Specifications: Vacuum must be maintained.

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Remove the fuel tank air filter. (Refer to Evaporative Emission Control System - Fuel Tank Air Filter)
3. 3
   Release the locking hooks (A) and separate the canister. Close the valve (B) of the fuel tank air filter (C) by turning it in the direction of the arrow in the illustration.

   

   

Installation

Install the component with the specified torque. Be careful not to drop the component, as internal damage may occur. If dropped, inspect it before use.

1. To install, reverse the removal procedure. Canister closure valve bolt: 3.9 ~ 5.9 N·m