Kia Forte BD Quiz
Engine Control System/Fuel System

Boost Pressure Sensor (BPS)

In this manual: Engine Control System/Fuel System
General Information — 8Maintenance — 32Engine Mechanical System — 47Engine Electrical System — 17Emission Control System — 10Engine Control System/Fuel System — 32Clutch System — 11Manual Transmission — 11DCT (Dual Clutch Transmission) System — 16Drive Shaft and Axle — 8Suspension System — 26Steering — 9Restraints — 11Brake System — 27Body (Interior and Exterior) — 119Body Electrical System — 98Heating, Ventilation, and Air Conditioning — 27
7steps
~42min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Specifications

Specification

Pressure
[kPa (kgf/cm², psi)]		 Output Voltage (V) [Vref=5V]
32,5 (0,33, 4,71) 0,5
284 (2,90, 41,19) 4,5

Description and Operation

Description

The Boost Pressure Sensor (BPS) is installed on the intercooler assembly and measures the pressure of the compressed air from the turbocharger.

Circuit Diagrams

Wiring Diagram

Harness Connector

Repair Procedures

Inspection

  1. Connect the KDS to the Data Link Connector (DLC).

  2. Measure the BPS output voltage with the engine idling and the ignition switched ON.

    Pressure
    [kPa (kgf/cm², psi)]    		 Output voltage (V)
    32,5 (0,33, 4,71) 0,5
    284 (2,90, 41,19) 4,5

Removal and Installation

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  2. Remove the air duct.

  3. Disconnect the boost pressure sensor connector (A).

  4. Remove the sensor (B) by loosening the mounting bolts.

    Boost Pressure Sensor Mounting Bolt:

    9,8–11.8 N·m

  5. Install in the reverse order of removal.

Test yourself

A quick Kia Forte BD quiz: every answer comes with an explanation and a link to the manual page.