Maintenance and owner do-it-yourself
Oil Filter Replacement
In this manual: Maintenance and owner do-it-yourself
8steps
~48min
2/5difficulty
Done 0 of 8

QR25DE
- Park your vehicle on a level surface and apply the parking brake.
- Switch off the ignition.
- Place a large drain pan under oil filter A.
- Loosen oil filter A with an oil filter wrench by turning it counterclockwise.

VQ35DE
WARNING
Take care not to burn yourself. Engine oil may be very hot.
- Wipe the oil filter mounting surface with a clean cloth.
WARNING
Make sure to remove all traces of the old gasket from the engine mounting surface. Otherwise, the engine could be damaged.
- Apply clean engine oil to the gasket of the new filter.
- Tighten the oil filter until light resistance is felt, then tighten it an additional two-thirds of a turn.
- Start the engine and make sure there are no leaks around the oil filter. If there are leaks, repair them.
- Turn the ignition off and wait more than 10 minutes. Check the oil level. Add engine oil as needed.
Test yourself
A quick Nissan Altima quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?